NORTH STATES 8615 Manual De Instrucciones página 3

INSTALLATION AND OPERATING INSTRUCTIONS
PRESSURE MOUNTING
Always use tape pads when using wall cups (door
sockets).
Note: Foam tape may leave a foam residue or
damage some wall surfaces when removed. Screws,
in addition to tape, may be used for added security.
Four longer screws are provided in hardware
package.
STEP 1
Place tape pads in recessed area of wall cups (door
sockets). See Figure 1.
STEP 2
Place gate on floor and expand in the opening with
handle on opposite side of area accessible to child.
See Figure 2. Be sure to adhere the wall cups (door
sockets) to the opening wall or surface where the
four bumpers touch. Remove the protective cover
sheet from one of the wall cups (door sockets) and
with the "U" upright, stick in place. Do the same on
the opposite side. The gate should be mounted flush
to the floor (or no more than 1
See Figure 3.
STEP 3
Mount the gate by aligning the four bumpers in the
wall cups (door sockets) and rotating the handle and
locking it into the slot that gives you enough tension
to secure the gate. See Figure 4.
STEP 4
To release the locking handle, press down on it
lightly, twist it outwards, and pull gently away from
the gate. See Figure 5.
HARDWARE MOUNTED
Used where additional security is required (top of the stairs etc.).
Warning: DO NOT MOUNT HINGES INTO SHEETROCK OR
PLASTER. HARDWARE IS INCLUDED FOR USE IN SOLID
MATERIALS ONLY, SUCH AS WOOD OR METAL.
BEFORE BEGINNING YOU MUST DETERMINE WHICH VERSION OF GATE
YOU HAVE BY MEASURING THE BUMPER SPACING ON YOUR GATE. SEE
FIGURE 6.
If this measures 21 3/8", follow dimension and figures A. If it measures 17 3/8",
follow dimensions and figures B.
/ " above the floor).
1
2
Figure 1
Figure 2
Figure 3
WALL CUPS
(DOOR
SOCKETS)
WALL CUPS
(DOOR
SOCKETS)
MAINTAIN SAME DISTANCE
FROM COMMON EDGE FOR
ALL FOUR WALL CUPS
(DOOR SOCKETS)
Figure 4
Figure 6
A = 21 3/8"
B = 17 3/8"
Page 3
Figure 5