Publicidad
ATTACHMENT SYSTEM
With the RAFIX SYSTEM, assembly
RAFIX BOLT
1) Insert the Rafix Bolt in the panel so
that the shoulder is flush with the
surface of the wood.
3) Place the Rafix Cam over the Rafix
Bolt in the panel.
RAFIX
is simplified.
Shoulder must
be flush with the
wood!
RAFIX CAM
2) Tap Rafix Cam into the appropri-
ate hole with the notch facing the
edge of the shelf. The flat edge of
the cam must be parallel with front
edge of piece.
Comfortable tightening by
positioning the screw driver at 25°.
4) Tighten Cam about a half turn
with a Phillips Screwdriver at a 25°
angle.
TOP VIEW
RAFIX SYSTEM — 8/03
Publicidad
