Publicidad
Q
Fig. 12
12. Slide the front leg/base assembly on to the front of the unit aligning the nine Rafix Bolts (R) into
the nine Rafix Cams (Q). See Figure 12. Tighten the cams.
T x 4
K
Fig. 13a
13. Spread a thin layer of glue on the two sides of the notch and top of the Back Leg (K). See
Figure 13a. With the notch snugly against the Left Side (Ca), attach the Back Leg (K) using
two #8 x 1-5/8" Screws (T). Make sure the back of the Back Leg (K) is flush with the back
edge of the Left Side (Ca). See Figure 13b. To add strength, use a Screw #8 x 2-1/2" (V)
through the top side of the Bottom Shelf (Ba) and into the Back Leg (K). See Figure 13c.
Repeat steps to attach the other Back Leg (K) to the Right Side (Da).
x 9
R
J
R
R
Q
R
K
Flush
Ca
Fig. 13b
R
I
R
Q
Q
V x 2
Ba
T
Back Edge
H
R
R
Q
Q
Ba
Fig. 13c
06/11 — 747Wa — Page 9
Ca
V
Top Side
Publicidad
