Metal Halide Lamps (Hit-De) And High Pressure Sodium Lamps - Reggiani UNITED Serie Instrucciones De Montaje

provided only, without altering the protective sheath and/or tampering with the internal
wiring.
• When wiring is completed
screws with an appropriate tool.
• For light beam adjustment (fig. ),
turn the projector - angles between +90°|0°|-90° -
ACCESSORIES
• BARN DOORS, ANTI-GLARE LOUVRE, ANTI-GLARE ATTACHMENT, COLOURED
FILTER HOLDERS
To mount the accessories (fig. ):
glass retention ring;
INSTALLATION/REPLACEMENT OF LAMPS
Each time the lamp is changed (fig 5), replace the optical compartment
gasket
in order to guarantee maintenance of IP66 degree of protection, (fig. )
Disconnect from the mains and follow the instructions given below
• HIT METAL HALIDE LAMPS (fig. )
To insert and/or replace the lamp, proceed as follows:
remove the glass retention ring locking screws;
Insert/replace the lamp with the same power as specified on the rating plate;
Before re-closing the optical compartment, replace the gasket;
Reposition the glass retention ring then tighten the screws clockwise alternately until
hermetic closure is obtained, so as to guarantee the stated IP degree.
•

METAL HALIDE LAMPS (HIT-DE) AND HIGH PRESSURE SODIUM LAMPS

(HST-DE) (fig. )
To install and/or replace the lamps, proceed as follows:
Remove the glass retention ring locking screws;
Install/replace the lamp (making sure the voltage matches that specified on the rating
plate) until you hear the click of the retaining spring;
Before re-closing the optical compartment, replace the gasket;
Reposition the glass retention ring then tighten the screws clockwise alternately until
hermetic closure is obtained, so as to guarantee the stated IP degree.
:High pressure sodium vapour lamp with external ignitor (however built into the
luminaire).
WEEE Luminaires are defined as Waste Electrical and Electronic Equipment (WEEE) and as such may not
be disposed of as solid urban waste. At the end of their life cycle, they must therefore be correctly treated
and disposed of as substances of concern for both the environment and human health due to the presence
of dangerous substances in the electrical and electronic components.
The user must therefore consign used luminaires to the distributor when purchasing an equivalent new luminaire
or, exclusively in the case of Italy, directly to Ecolight, the Consortium for the Disposal of Waste Electrical and
Electronic Equipment (Consorzio per lo Smaltimento degli Apparecchi di Illuminazione), delegated by Reggiani
S.p.A. Illuminazione, who will collect the equipment free of charge and delivery it to the special collection
facilities set up by the local authorities to recover, treat and dispose of WEEE.
The illegal or inappropriate disposal of said waste is punishable by economic and/or administrative sanctions
of the amount established by the law.
N.B. The free collection of a luminaire may be refused if there is a risk of contamination for the personnel
performing the service, if it is evident that the luminaire does not contain the essential components or if it
contains waste other than WEEE, or if the weight of the luminaire collected is more than double the weight of
the luminaire acquired. In these circumstances, disposal is the responsibility of the holder.
UNITED
reassemble the projector and completely tighten the safety
loosen the screws until a slight friction is obtained
iinsert the tabs in the relative seats in the projector
snap the clips provided into the glass retention ring;
(ordering code 1.20045.000 from Reggiani S.p.A. Illuminazione)
tighten the locking screws firmly.
7 ENGLISH