Dyna-Glo DGF510SSP Manual De Instrucciones página 12

ASSEMBLY INSTRUCTIONS
11. Carefully place the Grill body (C) onto Cart left
side panel assembly (P) and Cart right side
panel assembly (A1). Adjust the Grill body (C)
so that the holes in the Grill body (C) are
aligned with holes in the tabs of Cart left side
panel assembly (P) and Cart right side panel
assembly (A1).
Note: Make sure the gas hose/regulator
assembly is outside the cart. Secure the Grill
body (C) with 4 M6X16 screws (AA).
Hardware Used
AA
M6x16 Screw
12. Insert 2 M6x16 screws (AA) in left side of Grill
body (C) as shown, leaving 5mm of threads
exposed. Align key hole in Left side table
assembly (J) with the 2 screws just inserted
in the Grill body (C), and insert 3 M6x16
screws (AA) in the remaining holes in the Grill
body (C). Adjust Left side table assembly (J)
correctly, then tighten all screws.
Hardware Used
AA
M6x16 Screw
11
P
x 4
12
5mm
x 5
AA
12
C
A1
C
J
AA
AA