Operating The Tool; Maintenance - Dexter 150MD2.5 Instrucciones Legales Y De Seguridad

FR
ES

Operating the tool

PT
Hold the tool in your hand and get used to its weight, balance.
Examine the tool accessories carefully. Damaged accessories can fly apart as they come up to speed and should not be used. The use of damaged
IT accessories can result in serious personal injury.
Please well support and fix the workpiece before operation.
Practice on scrap materials first to see how the tool operates.
EL
Keep in mind that the work is done by the speed of the tool and by the accessory in the collet. You should not lean on or push the tool into the work.
It is best to make a series of passes with the tool rather than attempt to do all the work in one pass. To make a cut, pass the tool back and forth over
the work like you would a small paint brush. Cut a little material on each pass until you reach the desired depth. For most work, a gentle touch is best;
PL
you will have greater control, make fewer errors
For the best control in close work, grip the tool like a pencil between your thumb and forefinger.
A "hand grip" method of holding the tool is used for operations such as grinding a flat surface or using cut-
UA
RO
EN
Always disconnect the device before performing any adjustment or maintenance
operation. If the supply cord is damaged, it must be replaced by the manufacturer or its
service agent in order to avoid a hazard.
Disconnect from the power supply immediately if the supply cord is damaged.
Take care not to expose this tool to the rain.
If the carbon brushes need to be replaced, have this done by a qualified repair person (always
replace the two brushes at the same time).
Store the accessories in a dry place.
Regularly inspect the accessory, ensure the accessories are free of crack and surface defects.
Replace the accessory when it has worn out.
Cleaning
Avoid using solvents when cleaning plastic parts. Most plastic parts are susceptible to damage from various types of commercial solvents and
may be damaged by their use. Use clean cloths to remove dirt, carbon dust, etc.
Lubrication
All the bearings in this tool are lubricated with a su
conditions, therefore no further lubrication is required.
6. OPERATION

7. MAINTENANCE

nt work out of the accessory.
nt amount of high grade lubricant for the life of the unit under normal operating
174
s.