Descargar Imprimir esta página

Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

Frame Rail
Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 75519F
Wrenches: 12mm, 17mm
Drill Bits: None
1
Qty. (6)
M10 X 1.25 X 30mm Hex Bolt
1.
Lower the vehicle exhaust by removing the rubber isolator.
2.
Raise hitch into position and align with existing weldnuts in the frame rails.
3.
Loosely install the M10 X 1.25 X 30mm hex bolts and conical toothed washers on passenger side of vehicle.
4.
Install fasteners on driver side of vehicle and tighten all fasteners.
5.
Raise exhaust back into position by re-installing rubber isolator.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z
2006 Cequent Towing Products
Installation Instructions
Mitsubishi Endeavor
Fascia
Existing weldnuts
both sides of vehicle
Tighten all M10 CL10.9 fasteners with torque wrench to 53 Lb.-Ft. (72 N*M)
Do Not Exceed Lower of Towing Vehicle
Manufacturer's Rating or
Hitch type
Weight Distributing
Weight Carrying
Ball Mount
Wiring Access Location: SUV1, SUV2
Frame Rail
2
Qty. (6)
7/16" Conical Toother Washer
Sheet 1 of 3
75519N
Part Numbers:
75519
44561
87428
Max Gross
Max Tongue
Trailer WT (LB)
WT (LB)
NA
NA
3500 (1589 kg)
350 (159 kg)
12-13-06
Rev. A
Form: F205 Rev A 5-6-05

Publicidad

loading

Resumen de contenidos para Cequent Towing Products 75519

  • Página 1 This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684. Sheet 1 of 3 75519N 12-13-06 Rev. A 2006 Cequent Towing Products Form: F205 Rev A 5-6-05...
  • Página 2 Ce produit est conforme aux normes V-5 et SAE J684 de la V.E.S.C. (État de New York) concernant les spécifications en matière de sécurité des systèmes d’attelage. Feuille 2 de 3 75519N 12-13-06 Rev. A 2006 Cequent Towing Products Form: F205 Rev A 5-6-05...
  • Página 3 Este producto cumple con las especificaciones y requisitos de seguridad para conectar dispositivos y sistemas de remolque del estado de Nueva York, V.E.S.C. Regulación V-5 y SAE J684. Hoja 3 de 3 75519N 12-13-06 Rev. A 2006 Cequent Towing Products Form: F205 Rev A 5-6-05...

Este manual también es adecuado para:

4456187428