Description; Purpose; Overview; Packing List - GreenWorks CRD401 Manual Del Operario

Ocultar thumbs Ver también para CRD401:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 11
EN
1

DESCRIPTION

1.1

PURPOSE

The machine is used to cut all types of wood.
1.2

OVERVIEW

Figure 1.
Switch trigger
1
Lock-off Button
2
Spindle lock button
3
Hex key
4
Depth adjustment
5
lever
Bevel adjustment
6
knob
1.3

PACKING LIST

1 Circular saw
2 Hex key
3 Cutting blade
4 Edge guide
5 Dust tube with a screw
2

SAFETY

Make sure that you do/obey all safety instructions.
Refer to Safety Manual.
3

INSTALLATION

3.1

UNPACK THE MACHINE

Make sure that you correctly assemble the machine before
use.
If parts of the machine are damaged, do not use the
machine.
If you do not have all the parts, do not operate the
machine.
If the parts are damaged or missing, contact the service
center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
Edge guide
7
Width adjustment
8
knob
Lower guard
9
10 Base
11 Lower guard lever
12 Tube
6 Manual ( operation
manual, safety
instruction manual,
figure sheet )
WARNING
WARNING
WARNING
English
5. Discard the box and package in compliance with local
regulations.
3.2

INSTALL THE BATTERY PACK

Figure 2.
If the battery pack or charger is damaged, replace the
battery pack or the charger.
Stop the machine and wait until the motor stops before
you install or remove the battery pack.
Read, know, and do the instructions in the battery and
charger manual.
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
3.3

REMOVE THE BATTERY PACK

Figure 2.
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
3.4

INSTALL THE BLADE

Figure 3.
Before you install the blade, remove the battery pack from
the machine.
1. Use the lower guard lever to lift the lower guard and hold
the lever.
2. Install the new blade.
3. Put the outer flange and the blade bolt on the spindle.
4. Push the spindle lock button to lock the spindle.
5. Use the hex key to tighten the bolt clockwise.
The arrow on the blade points the same direction as the
arrow on the top guard.
3.5

REMOVE THE BLADE

Figure 4.
Before you remove the blade, remove the battery pack.
1. Push the spindle lock button to lock the spindle.
2. Use the hex key to loosen the blade bolt
counterclockwise.
4
WARNING
NOTE
NOTE
NOTE

Publicidad

Tabla de contenido
loading

Tabla de contenido