Cooper Lighting WIS Instrucciones De Instalación página 2

Installation Instructions - WIS - Lumiere Instructions
INSTALLATION
ACCENTS
1. Unpack and ensure all included parts are present.
2. Unscrew 4x mounting hardware from driver mounting
plate, separate the Luminaire Disconnect to separate
driver mounting plate from fixture assembly.
3. Connect building AC supply wires from junction box to
input wire side of LED driver with push nuts (included).
Ensure excess ground wire can extend out of junction
box.
N ote: Junction boxes must be min size of 2-1/8" deep
and 4" square. Recommended Junction boxes are
Crouse-Hinds part numbers TP403, TP432, TP434,
TP438, TP395, or equivalent.
Driver Mounting Plate
Driver
RD
BK
Push Nuts
GN
Ground Wire
Mount Plate and Gasket
Fixture Assembly
Figure 1.
4. Separate and route Luminaire Disconnect and ground
wire out of center hole in driver mounting plate, Attach
driver mounting plate to existing junction box with
proper hardware (not included).
5. Re-connect ground wire and Luminaire Disconnect to
fixture assembly.
6. Attach mount plate and gasket to driver mounting
plate with 4x mounting hardware. Ensure adequate
gasket compression to provide proper seal from the
environment.
2
COOPER LIGHTING SOLUTIONS IL514001EN
8-32 Nuts
Luminaire Disconnect
Mounting Hardware
Knuckle
Installation instructions
Driver Mounting Plate
RD
BK
GN
Ground Wire
Mount Plate and Gasket
Fixture Assembly
Figure 2.
7 . Using a 3/32" Allen Wrench, slightly loosen the set
screw at knuckle base for rotational adjustment. Using
a 9/64" Allen Wrench, slightly loosen the screw at
the knuckle joint for angle adjustment. Once properly
positioned, ensure both screws are secured.
Mount Plate and Gasket
Fixture Assembly
Figure 3 .
Luminaire Disconnect
Mounting Hardware
Knuckle
Knuckle Base Set Screw
Knuckle Joint Screw