cam VOLARE Manual De Instrucciones página 9

ImPORTANT: RETAIN THESE
INSTRUCTIONS FOR FUTURE
REFERENCE. READ CAREFULLY.
1. WARNING: Do not leave your child unattended. 2. WARNING: Drowning can occur in
very short time even in low water (2 cm). 3. WARNING: Max. water level to avoid child's
drowning is 15 cm. 4. WARNING: The product does not offer any protection against water
and drowning could occur in the bath itself. 5. WARNING: do not leave the plug at your
child's reach 6. WARNING: Be careful with the water temperature (max 37°C/99°F) to
prevent your child from getting burned. 7. WARNING: The bath is suitable from birth till
12 months of age. 8. WARNING: Check the stability of the product before using it.
9. WARNING: Cam il Mondo del Bambino S.p.A. reserve the right to modify the product
for technical or commercial reasons without prior notice. 10. WARNING: This product
must be used for the means that it was designed for any misuse and the manufacturer
declines all responsibility. In case of defected, broken or missing parts, do not use the
product. Never use replacement parts other than those supplied by the manufacturer.
11. WARNING: This product is suitable for children up to 15 kg weight. 12. WARNING:
All assembling parts must be always assembled properly and checked regularly.
13. WARNING: Never leave this product near to any strong heat source as it could cause
fire. Open fires, heating appliances, electric bar or gas fire can cause a real risk if the
product is placed in their vicinity. 14. WARNING: The bath must be kept at all the times
in position within the frame, even if only being used as a changing station. Pls check
that the safety press studs are locked when using the changing mat. To clean the
changing unit use warm water and soap or mild detergent. Do not use bleach or use
abrasive cleaners. 15. WARNING: the bath must be used with one baby at a time.
16. WARNING: Use the bath only in the bath tub or only on bath stands approved by the
manufacturer. Check stability of the product assembled before using it.
ASSEmBLY INSTRUCTIONS
➢ In order to assemble this product, you will
require a screwdriver and a spanner. Make sure
that all screws and assembling devices are well
tightened and not loosen, as they could hurt
your child or put him in a serious danger.
1. Open completely the frame (FIG. 1). Firmly
insert the 4 feet "C" (PART. 1).
2. Insert the round housings (PART. 2) of the
plastic basket "D" on the pins (PART. 3) of the
frame (FIG. 2/A). Slide the basket "D" (FIG. 2/b)
until the holes on the basket are in position
with the holes on the frame (PART. 4) and screw
in the self tapping screw "X" (PART. 5).
ATTENTION: before continuing assemblying
the product, make sure the side protections are
locked, pushing them downwards.
3a. Screw in button "H" through screw "Y" and
bolt "M4 (diagram nr 6).
3b. Screw in button "H" through screw "Z".
4. Place the bath onto the frame and push until
you hear a "click" on the frame (FIG. 4).
5. Insert the drainage tube and its pipe (FIG. 5).
6a. Assemble metal bar with the plastic hinges
"N" and screws "E".
6b. OPTIONAL: if included, screw in handle "M"
with through screws "B".
INSTRUCTIONS FOR USE
7. Put the changing top with its arms on the
frame (FIG. 7) and insert the 2 edges of the
changing top arms on the holes on the frame.
Then assemble the metal cover caps on these
edges (PART. 7).
8. Fit the accessory tray on the plastic shelve
(FIG.8/a): make it slide till the desired position
(FIG.8/b).
INSTRUCTIONS FOR SAFE USE
a. To fold the frame, unlock safety buttons, lift
the changing mattress and turn it till you reach
the folding position, remove the plastic bath
(diagram A).
b. Lift the 2 side protections simoultaneously
(FIG. b1) pulling towards yourself the top (FIG.
b2).
c. Then close the frame.
d. The changing unit is very compact once
folded.
e. ATTENTION: For the correct use of the
changing top, the changing unit must be at
least 35 cms away from any solid surface.
ThIS ITEm COmPLIES WITh ThE EUROPEAN
SAFETY STANDARD EN 12221-1/2:2008.
08