METRO PROFESSIONAL GCV1100 Manual De Instrucciones página 12

malfunctions or has been
damaged in any manner.
4. Protect the power cord against
damages. Do not let it hang
GB
over sharp edges, do not
squeeze or bend them. Keep
the power cord away from
hot surfaces and ensure that
nobody can trip over it.
5. Do not insert fingers or foreign
objects in any opening of the
appliance and do not obstruct
the air vents.
6. Protect the appliance against
heat. Do not place close to
heat sources such as stoves
or heating appliances.
3. Operation
Placement
• Place the appliance on a stable and level surface.
• Ensure the appliance is properly levelled using a
water spirit level. Turn the adjustable feet to level
the appliance as necessary.
• Let the appliance rest in its intended position for
a minimum of 2 hours before operating to prevent
damages to the cooling circuit through shaken
refrigerant.
Switching the appliance on/off
Switch
off position (O) – appliance is switched
off
on position (I) – appliance is switched
on
Notes:
• The on position (I) is indicated by an illuminated
switch.
• The appliance will emit an audible signal when
switched on.
• Always switch the appliance off before
unplugging.
Function
• Wait at least 5 minutes before switching the
appliance on again after switching the appliance
off, unplugging or a power break.
• We recommend switching the appliance off and
unplugging it when not in use.
Operating panel
Button Function
press to set the cooling temperature
afterwards with the
press again to exit the temperature
setting
press to increase the cooling temperature
press to decrease the cooling
temperature
Indicator Function
displays the numeric value of the
compartment / cooling temperature
a dot will appear on the display below
the following symbols to indicate their
current state
Notes:
• Pressing the SET button enters the temperature
setting and the display changes from
compartment to cooling temperature. Pressing
the SET button again exits the temperature
setting and the display changes from cooling to
compartment temperature.
• 10 seconds without input exits the temperature
setting.
• Every press of a button is confirmed with an
audible signal.
- 11 -
press to switch the light on or off
press and hold (> 6 seconds) to
switch the (manual) defrosting
on or off
and
on cooling active
off cooling inactive
preparing cooling
flashing
process
on defrosting active
off defrosting inactive
skipped scheduled
flashing
defrosting
buttons