KlipXtreme KTM-876 Guia Del Usuario página 2

IMPORTANT:
At least two qualified people should perform the assembly procedure. Personal
injury and/or property damage can result from dropping or mishandling the display.
Maximum at or curved panel weight: 30kg/66lb
The wall structure must be capable of supporting at least five times the weight of
the panel. Otherwise, the wall structure must be reinforced.
2 - WARNING!
• Prior to installing this product, you must read all instructions thoroughly. Keep these
installation instructions in an easily accessible location for future reference.
• Safety measures must be practiced at all times during the assembly of this product.
Use proper safety equipment and tools for the assembly procedure to prevent
personal injury.
• KlipXtreme does not warrant against damage caused by the use of any KlipXtreme
mounts for purposes other than those for which it was designed or damage caused
by unauthorized attachments or modifications, and is not responsible for any
damages, claims, demands, suits, actions or causes of action of whatever kind
resulting from, arising out of or in any manner relating to any such use, attachments
or modifications.
3 – Attaching the mounting plate to the back of the screen
1. Open the package and review its contents.
2. The VESA mounting plate comes with four screws preinstalled; two at the top and
two at the bottom of the piece that is used to attach it to the wall assembly. Using
a Phillips screwdriver loosen the top two screws and remove the bottom ones to
separate both parts. Save these screws as you will need them to attach both parts
again later on. (Section Final assembly – No. 2).
2
3. Place your flat panel screen TV side down on a soft, even surface, and identify the
threaded mounting points that are located on the back of the unit.
4. Determine the correct screw size (M-A, M-B, M-C) by carefully measuring the depth
of the mounting point. Please note that not all the hardware included will be used.
5. Also determine the VESA pattern that matches your TV and use the supplied
extensions accordingly
6. Attach the mounting plate to the panel by aligning the holes on the plate with the
threaded inserts on the back of the display.
7. Use the selected screws and the flat washers M-D (D8) to secure the plate to the
display. Be careful not to overtighten the screws. Please note that flat washers are
not necessary when using M8 screws (M-B, M-C).
8. If using the plate extensions, make sure to secure all four extenders with a nut
wrench, as shown in the drawing.
3