Publicidad
Idiomas disponibles
Idiomas disponibles
1
Front protective cage
2
Protective cage locking screw
3
Rotor mounting screw
4
Rotor blade
5
Rear protective cage
6
Mounting screw
7
Extension rod
8
Stand
9
Connector
5. Assembly
Take the fan out of the package and check the appliance as well as the scope of
delivery mentioned in the table above. Please contact the supplier if any part is
missing or has been damaged.
1.
Place the rear protective cage (5) on the motor unit.
2.
Tighten the rear protective cage (5) firmly using the mounting screw (6).
3.
Place the rotor blade (4) on the motor unit and screw it firmly using the rotor
mounting screw (3).
4.
Place the front protective cage (1) on the rear protective cage (5) and tighten
it as previously shown in the picture.
5.
Fasten the protective cages (1 + 5) using the protective cage locking screw
(2).
6.
Fix the extension rod (7) on the stand (8) optionally.
7.
Please insert the assembled motor unit on the extension rod (7) or on the
connector on the stand (9) (depending on the preferred height).
8.
Please connect the power cable first to a properly installed socket.
9.
Make sure that the 2 projecting pins are inserted into the 2 concave holes of
the base or the centre stand and fixed.
10.
To remove the individual elements again, a knob is provided at the respec-
tive fixing points to unlock the rod and then remove it.
28
English
Publicidad
