Thicknessing - HOLZMANN MASCHINEN HOB 260ABS Instrucciones De Servicio

17.8.3 Thicknessing

Wood feed device: The wood is automatically fed by two spring-loaded rollers. Press the
workpiece against the thicknessing table only until the workpiece is gripped by the feed roller.
Allow the workpiece to pass through without pushing.
A long workpiece should be supported both when entering and leaving the machine to avoid
"heels" at the end of the wood.
HOLZMANN MASCHINEN GmbH
NOTICE:
longitudinal hole at the front of the machine. For this
reason, the machine can only be started when the
dust collector brackets are fully engaged.
NOTICE:
reverse order.
NOTICE:
machine has reached full operating speed (approx. 5
seconds from start).
www.holzmann-maschinen.at
 Now you need to install dust collector to the
surface of the entry planer table.
 Both brackets (6) need to correspond in their
position with the longitudinal boreholes (7) at
the entry planer table.
 Then press both brackets (6) into the
longitudinal boreholes until you hear a clear
"clicking sound".
a safety switch is integrated in the
when convertinging to planing, proceed in
NOTICE
For readjusting to planer mode please lower
the thicknesser table to avoid any damages.
 Loosen the clamp (3) and adjust the desired
cutting depth (height of the planer table) with
the hand wheel (4).
 The scrrent table height is displayed on the scale
(2).
 Adjust table height to workpiece thickness minus
the desired chip removal.
 Maximum chip removal: see technical data!
 Fix the adjusted cutting depth with table clamp
(3).
 Switch on the machine by pressing the ON-
button.
 Move the lever (1) to the upper position to the
thicknessing-position.
Activate the feed device only after the
 Insert the workpiece so that the surface to be
planed faces upwards and slide it forward.
OPERATION
50
HOB 260ABS