Installation; DinFront/RearMount - Jensen MP1514BT Manual Del Propietário

INSTALLATION

It's a good idea to read all of the instructions before beginning the installation. We
recommend having your Jensen MP1514BT Mobile Audio System installed by a
reputable installation shop.
Notes:
• Choose a mounting location where the unit will not interfere with the driver.
• Before installing the unit, temporarily connect the wiring. Make sure it is
connected up properly and the unit and the system work properly.
• To ensure proper installation, use only parts included with the unit. The use of
unauthorized parts can cause malfunctions.
• Consult with your nearest dealer if installation requires the drilling of holes or
other modifications to the vehicle.
• Install the unit where it does not get in the driver's way and cannot injure the
passenger if there is a sudden stop, like an emergency stop.
• If the installation angle exceeds 30° from horizontal, the unit might not give its
optimum performance.
• Avoid installing the unit where it would be subject to high temperature, such as
from direct sunlight, or hot air from the heater, or where it would be subject to
dust, dirt or excessive vibration.

DINFront/RearMount

This unit can be properly installed either from "Front" (conventional DIN Front-
mount) or "Rear" (DIN Rear-mount installation, utilizing threaded screw holes
at the sides of the unit chassis). For details, refer to the following illustrated
installation methods.
Remove the Transport Screws Before Installation
Before installing the unit, remove the two transport screws.
Remove screws
before installation.
6
30