Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
EN
SAFETY INSTRUCTIONS
•
Do not install the product in a damp or dusty environment
•
Install the NVR in a well ventilated environment
•
Check the power supply before installing the NVR to avoid problems caused by inappropriate power
supply
•
Install the NVR on a flat, horizontal, vibration-free surface
•
If dust gets into the mainboard, it may cause a short circuit if it gets wet. Wipe the mainboard dust,
connectors, and NVR casing
•
If the battery is discharged, use the same type of battery. Do not open or attempt to repair the battery.
•
Use only Hard Disks recommended for surveillance systems to ensure continuous and stable recording
NVR INSTALLATION SCHEME
POSITIONING IP CAMERAS
The shape of the wireless signal coverage area is round, with the antenna positioned in the center. The signal
is stronger around the antenna. Based on how to spread the wireless waves, position the IP cameras parallel
or perpendicular to the NVR to provide a stable signal and quality images.
INSTALLATION INSTRUCTIONS
1.
Make holes in the wall at least 30 mm deep
2.
Fix the camera on the wall. Use 3 PA4 screws
3.
Unscrew the screws on the bracket to rotate the camera as needed
4.
Remove the Hard Disk into the NVR. Be sure to disconnect the power before installation
NVR REAR PANEL DESCRIPTION
Correct positioning
Antenna
AUDIO
output
2
Incorrect positioning
Ethernet USB2.0
HDMI
VGA
Power supply
output
output
12V DC
Publicidad
Tabla de contenido
