Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
6 mm set screw
Indicator
(for left bevel scale)
6 mm hex. socket
screw (B)
3.
Installing the holders ... (Optional accessory)
6 mm knob bolt
(Optional accessory)
Holder
(Optional
accessory)
Steel square
6 mm
wing nut
Height adjustment bolt 6 mm
(Optional
(Optional accessory)
accessory)
(2) After adjustment, fi rmly tighten the 6 mm wing nut and fasten the holder with the 6 mm knob
bolt (optional accessory). If the length of height adjustment bolt 6 mm is insuffi cient, spread
a thin plate beneath. Make sure the end of height adjustment bolt 6 mm does not protrude
from the holder.
Fig. 9-a
Base surface
Fig. 10
Set button
Press
6 mm hex.
Angle
socket screw (A)
block (B)
Angle block (A)
Angle
block (A)
The holders help keep longer workpieces
stable and in place during the cutting operation.
(1)
As indicated in Fig. 10, use a steel square
for aligning the upper edge of the holders
with the base surface. Loosen the 6 mm
knob bolt. Turn a height adjustment bolt
6 mm, and adjust the height of the holder.
English
Indicator
(for right bevel scale)
Angle block (B)
Fig. 9-b
17
Publicidad
Tabla de contenido
