Sharpening Saw Chain; Environmental Protection - Lista MPB-20 Manual De Instrucciones

make cutting harder.
Fit the Bar Tensioning Plate Tab into the new
bar by tightening the screw clockwise. The tab
protrusion (b) must be fitted into the bar hole. (See
Fig. K)
K

SHARPENING SAW CHAIN

WARNING: Remove the battery pack
before servicing. Severe injury or death
could occur from electrical shock or body
contact with moving chain.
Cutting edges on chain are sharp. Use
protective gloves when handling chain.
Keep chain sharp. Your saw will cut faster
and more safely. A dull chain will cause undue
sprocket, Guide Bar, chain, and motor wear. If you
must force chain into wood and cutting creates
only sawdust with few large chips, chain is dull.
Lubricate Sprocket
WARNING: Wear heavy duty gloves when
performing any maintenance or service
to this tool.
Always remove the battery pack before performing
any service or maintenance on this tool.
NOTE: It is not necessary to remove the chain
or bar when lubricating the guide bar sprocket.
1. Clean the bar and sprocket
2. Using a grease gun, insert the tip of the gun
into the lubrication hole and inject grease until
it appears at the outside edge of the sprocket
tip. (See Fig. L)
3. To rotate the sprocket pull the chain by
hand until the ungreased side of the sprocket
is in line with the grease hole. Repeat the
lubrication procedure.
62
L
For Battery tools
The ambient temperature range for the use and
storage of tool and battery is 0°-45°.
The recommended ambient temperature range for
the charging system during charging is 0°-40°.
ENVIRONMENTAL
PROTECTION
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with
your local authorities or retailer for recycling
advice.