Miele professional WS 5425 Manual De Instrucciones página 11

,
Before any service work is commenced, the machine must be disconnected from the
mains.
,
Service and repair work should only be carried out by suitably qualified persons in
accordance with all appropriate local and national safety regulations.
C 4060 / C 5002 For programme operation only
C 5003 For timed operation only
C 4065 / C 4070 For programme or timed operation
I. WS 5425 / WS 5426
T 5205 / T 5206
PW 5065 PW 6055 PW 6065 PW 6080
PT 5135C PT 5136 PT 7135C PT 7136 PT7186
WS 5073
T 6185
^ a) Fix the template, Fig. 1, on the machine lid and drill 6.5 mm C holes.
Dimensional table for drilling template:
PW 5065, PW 6055, PW 6065, PT 5135C, PT 5136, PT 7135C, PT 7136
WS 5073, T 6185, PW 6080, PT 7186
WS 5425, WS 5426, WS 5435, WS 5436, WS 5445, WS 5446, T 5205, T 5206
Ia. WS 5425 / WS 5426
T 5205 / T 5206
^ b) Open the coin mechanism front panel, place the rubber mat, Fig. 2 (1), on the machine lid
above the drilled holes and secure the coin mechanism in position on the machine lid with
the fixings supplied. (If necessary, fit the reinforcement, Mat. no. 04 043 580, and locking
plate, Mat. no. 04 438 220 (7)).
^ c) Remove the cable strain relief, Fig. 2 (2), from the rear panel, pass the connection cable
(3) through and connect the plug (4) to the 7-pole round connector (5) already fitted in the
machine.
Warning!: With C 4065 and C 4070, an adapter (8) may be required (see note with the
adapter, Mat. no. 05 688 611). Secure the adapter to the wiring harness with a cable tie.
^ d) Disconnect the bridge W14, Fig. 2 (6), on the round connector (5) with C 4065 and C 4070
in accordance with the note with the adapter, Mat. no. 05 688 611.
With C 4060 and C 4070, proceed in accordance with the wiring diagram supplied with the
machine.
^ e) For safety reasons the connection cable (3) must not be longer than 2.5 m.
M.-Nr. 05 719 361 / 00
WS 5435 / WS 5436
Model
WS 5435 / WS 5436
WS 5445 / WS 5446
Dimension Z Dimension W
80 mm
90 mm
42 mm
WS 5445 / WS 5446
35 mm
28 mm
28 mm
11