Confirm Proper Operation; Operating Sequence - Kohler K-1111-H2 Guia De Instalacion

Activates Mode
Selected
Rotate outer
ring to access
desired mode.
Chromatherapy -
Specific Color
Lighted User Keypad
13. Confirm Proper Operation
Fill the Whirlpool
NOTE: Please read these steps carefully before you operate your whirlpool.
Turn the jet trim rings fully counterclockwise. Position the jet nozzles so they face down toward the
basin.
Fill the whirlpool with water until the water level is above the highest backjet.
NOTE: The water temperature in the whirlpool should not exceed 104°F (40°C). The heater will
automatically turn off as the water temperature approaches 104°F (40°C) and will remain off until the
water cools.

14. Operating Sequence

NOTE: A built-in heater automatically helps to maintain the water temperature when the whirlpool is
running, as long as the water temperature does not exceed 104°F (40°C). The heater will disengage at
higher temperatures.
IMPORTANT! Please refer to your Homeowners Guide for detailed instructions on the user keypad and
remote control.
Press the Power On/Off button on the keypad to turn the whirlpool on. The whirlpool will start at
medium flow and three small lights near the whirlpool floor will illuminate as long as the keypad
remains lit.
Increase or decrease the water flow by pressing either the up or down arrow buttons on the keypad.
An indicator bar in the center of the keypad shows the water flow volume.
Adjust each Flexjet for optimum air/water mixture. Turn the Flexjet trim clockwise to reduce the air
flow and counterclockwise to increase the airflow.
Rotate the outer ring until the heater button is flashing. Press "OK" to turn the heater off. Press
"OK" again to turn the heater back on. The heater will help to maintain the water temperature up to
104°F (40°C).
Press the Power On/Off button a second time to turn the whirlpool off. The lights near the
whirlpool floor will remain illuminated until the keypad enters the sleep mode.
NOTE: A built-in timer automatically stops the pump and motor after approximately 20 minutes of
operation.
1042951-2-C
Flexjet Flow Mode
Power
On/Off
Heater
On/Off
Increases Flow
or Pulse Rate
Indicator Bar - Shows
water flow volume or
pulse rate
Chromatherapy
Cycle
Decreases
Flow
12
Turn the jet trim
clockwise to
decrease the flow.
Turn the jet trim
counterclockwise to
increase the flow.
Kohler Co.