EQUATION TH10AM Manual De Instrucciones página 13

INTRODUCTION
The room thermostat turns the heating system on and off to obtain the desired temperature (set temperature).
It detects the air temperature and compares it with the set temperature. If the room temperature is lower than
the set temperature, the thermostat turns on the boiler, and turns it off when the set temperature is reached,
and so on.
To obtain an optimum setting, set a low temperature (18°C for example) and increase degree by degree each day
to reach the temperature that suits you (comfort temperature).
The thermostat does not aff ect the power of the boiler, so there is no need to set a higher temperature to heat
faster.
If the radiators have valves (manual or thermostatic) make sure that the radiators located in the same room as
the thermostat are open.
The thermostat is compatible with modulating boilers, but with a reduction in performance.
INSTALLATION
The thermostat must be installed on a wall away from any source of heat (fi replace, radiator, sun) and
drafts (window, door), at a height of 1.2 m to 1.5 m.
It must be connected to the inputs for a "ON/OFF" remote thermostat (T1 and T2) of a boiler, regardless
of the polarity. The diagram on the label stuck in the box corresponds to the particular case of a series
connection to the boiler supply. In this case, it is important to connect phase (L) to terminal 1 of the
thermostat.
The installation must be carried out by a person possessing the required qualifi cations while respecting
the national wiring standards in force.
Processing waste of electronic and electric devices at life-cycle end.
This image indicates that this product must not be disposed of with unsorted home trash. A
system for disposal and special processing of used electric and electronic devices, manda-
tory to follow, has been implemented including the right to have vendors retrieve free-of-
charge used appliances upon purchase of new appliances, as well as special collection of
such waste by approved organisations.
For more information on this, you can contact your store or your town hall. Proper disposal of
used electric and electronic appliances ensures their adequate processing and recycling in order to avoid
damage to the environment and public health as well as to preserve natural resources.
Type of Control
Electrical protection
Temperature range
Action
Rated current
Environment
Regulation class
(according 811/2013)
Energy effi ciency gain (contribution to seasonal space heating energy effi ciency)
Overvoltage Category according IEC/EN 60730-1
Supplier
Technical data
Independently mounted mechanical control for Surface mounting
IP30 No protection against water ingress
CLASS II Product that does not incorporate protective earthing provision,
but a double insulation as provision against electric shock
10-30°C
Micro-interrupt, Type 1 .C
Rated voltage : 24-230V~, 50-60Hz - Max rated current on Terminal 3 For Resistive
load : 10A - Max rated current on Terminal 3 for Inductive load : 3A
Pollution degree = 2 (standard household conditions without conductive dust)
Class I
ADEO Services - 135 Rue Sadi Carnot, CS 00001, 59790 - RONCHIN - FRANCE
Rated impulse voltage
II
FR
ES
PT
IT
EL
PL
UA
RO
EN
2500 V
1%
13