Erreka DINGO Guía Rápida De Instalación Y Programación página 9

DINGO
Quick installation and programming guide
This quick guide is a summary of the complete installation manual. The manual contains safety warnings and
other explanations which must be taken into account. The installation manual can be downloaded by going
WARNING
to the "Downloads" section of Erreka website:
http://www.erreka-automation.com
Electrical wiring
A: Main power supply
B/E: Flashing light with
antenna
C: Photocells (Tx / Rx)
D: Pushbutton/wall key
Assembly levels
36mm
210mm
Unlocking
Unlocking for manual operation:
• Insert the key (1) and turn clockwise 180º without
forcing it: the rack drive pinion will come down from
its operating position, releasing the rack.

Install the rack at a height
75mm
between 75 and 95 mm.
95mm
85mm
90 mm is recommended as the
reference height.
C259A
Unlocking
180º
D259A
Elements of the complete installation
Locking
Motorised operation locking:
• Insert the key and turn it anti-clockwise 180º as far as
it will go. The pinion will return to its work position, in
contact with the rack.
• Activate a key device in order for the gate to carry out
a "reset".
English
E259A
180º
D259B
9