Craftmade Crescent D52 Instrucciones De Instalación página 4

6
Insert wires, including steel cable, from top of support rod (#7) through
hole "A" in bottom of "support arm distributor" (#8). Insert ends of
remaining two rods into holes "B" and "C" in bottom of distributor.
Place wires through hex nut and tighten nut securely onto support rod.
Use hex nuts to secure remaining two rods into place. Insert wires
through hole "D" and pull through top of downrod section of distributor.
Side View of Support Arm
Distributor Assembly (#8)
D
A
Hex Nut
CAUTION:
Do not mount fan to sheet rock or
drywall type materials. To insure
proper support use the two #1 wood
screws to secure mounting bracket to
joist or beam, if the location you
have chosen does not have a suitable
support beam, install a 2" x 4" brace
between ceiling joists to support fan,
or one of the many NEC and UL
approved ceiling fan braces.
WARNING:
To reduce the risk of fire, electric shock or personal injury, mount to outlet box
marked "acceptable for fan support" and use mounting screws provided with
the outlet box. Most outlet boxes commonly used for the support of lighting
fixtures are not acceptable for fan support and may need to be replaced.
Consult a qualified electrician if in doubt.
Step 6
Downrod Section
B
Wiring Harness
Support Rod (#7)
(including steel wire)
A
C
B
Top View of Support
Arm Distributor (#8)
7
Step 7
Locate downrod assembly (#2).
Loosen ball screw on black hanging
ball to free lock pin. Black hanging
ball will slide down. Remove ground
screw and green ground wire.
Remove hanging ball from downrod
and save all parts. Insert wires and
steel cable from distributor assembly
through downrod. Screw downrod
into top of Support Arm Distributor
Assembly (#8), being careful that
wires are pulled through.
8
Position downrod so the hole in the downrod aligns with the hole in the
distributor assembly. Insert safety bolt (S10) through distributor assembly
and downrod and attach nut. Tighten firmly. Tighten set screw "A"
against downrod. Place distributor cover (#8a) over support arm
distributor (#8). Next place canopy (#3) over downrod assembly (#2).
Replace hanging ball, insert hanging pin through downrod and tighten set
screw "C" in hanging ball into downrod.
Threaded Set
Screw Hole
Ground
Hanging
Wire
Pin
Ball
Screw
Hanging
Ball
Safety Bolt
WARNING:
Failure to completely tighten downrod as described in steps 7 & 8 above could
result in the fan loosening and possibly falling.
Lock Pin
Green Ground
Wire
Ball Screw
Downrod
Assembly
Hanging Ball
(#2)
Downrod
Support Arm
Distributor
Assembly (#8)
Step 8
Set Screw (C)
Downrod (2)
Canopy (3)
Distributor
Cover (8a)
Set Screw (A)
and Nut
Distributor
Assembly (2)