Wayne Dalton TorqueMaster Plus 9100 Instrucciones De Instalación Y Manual Del Propietario página 15

8
Stacking Sections
NOTE: For door section identification see
Tools Needed:
page 4.
Power Drill
NOTE: Make sure hinges are flipped down,
7/16" Socket
when stacking another section on top.
Driver
Place rollers in hinge tubes of the second
section (lock section). With assistance,
lift second section and guide rollers into
the vertical tracks. Keep sections aligned
and fasten hinges to connect the sections
using 1/4"-14 x 5/8" self tapping screws.
Repeat for other section(s) except top
section.
IMPORTANT: PUSH & HOLD THE HINGE
LEAF AGAINST SECTION WHILE SECURING
WITH 1/4"-14 X 5/8" SELF TAPPING
SCREWS. END HINGES HAVE (2) SCREWS
AND INTERMEDIATE HINGES HAVE (3)
SCREWS.
NOTE: Install lock at this time (sold
separately) see instructions in OPTIONAL
SIDELOCK INSTALLATION on page 40.
9
Tools Needed:
To install the L-shaped top brackets,
align the top holes in the top bracket
Power Drill
base with the second set of holes in the
7/16" Socket
endcap of the top section.
Driver
Fasten using (4) 1/4" - 14 x 5/8" self
tapping screws. Secure the top bracket
slide to the bracket base loosely using
(2) 1/4" - 20 x 5/8" carriage bolts and
(2) 1/4" - 20 flanged hex nuts. The
bracket will be tightened and adjusted
in Step 16. Insert rollers into top bracket
slide. Repeat for other side.
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com
Top Brackets
(2) 1/4"-14 X 5/8"
SELF TAPPING SCREWS
END HINGES (LEFT HAND SHOWN, RIGHT
HINGE SYMMETRICALLY OPPOSITE)
1ST SET
TOP SECTION
2ND SET
TOP BRACKET BASE
TOP BRACKET SLIDE
TOP SECTION
TOP SECTION
(3) 1/4"-14 X 5/8" SELF TAPPING
SCREWS
INTERMEDIATE HINGES
(4) 1/4" - 14 x 5/8"
SELF TAPPING
SCREWS
(2) 1/4" - 20 x 5/8"
CARRIAGE BOLTS
(2) 1/4" - 20
FLANGED HEX
NUTS
ROLLER
TOP BRACKET SLIDE
15