Wayne Dalton TorqueMaster Plus 9100 Instrucciones De Instalación Y Manual Del Propietario página 19

14
Attaching Horizontal Track to
Quick Install Flagangle
NOTE: If you have fully adjustable
Tools Needed:
flagangle, skip this step and complete
9/16" Socket
Step 15.
Ratchet Wrench
To install horizontal track, place the
9/16" Wrench
curved end over the top roller. Align
Level
key slot of the horizontal track with the
quick install tab of the flagangle. Push
curved portion of horizontal track down
to lock in place.
WARNING
DO NOT RAISE DOOR UNTIL
HORIZONTAL TRACKS ARE SE CURED
AT REAR, AS OUTLINED IN STEP 30, OR
DOOR COULD FALL FROM OVERHEAD
POSI TION CAUSING SEVERE OR FATAL
INJURY.
Level the horizontal track assembly and
bolt the horizontal angle to the slot in
the flagangle using (1) 3/8" - 16 x 3/4"
truss head bolt and (1) 3/8" - 16 hex
nut. Repeat for other side. Remove the
nail that was temporarily holding the
top section in place, installed in Step
13.
IMPORTANT: FAILURE TO REMOVE NAIL
BEFORE ATTEMPTING TO RAISE DOOR
COULD CAUSE PERMANENT DAMAGE
TO TOP SECTION.
NOTE: If an
installed, position horizontal tracks
slightly above level.
NOTE: After completing this step,
continue with Step 16.
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com
idrive
opener will be
®
HORIZONTAL
TRACK
QUICK
INSTALL
TAB
VERTICAL
TRACK
HORIZONTAL
QUICK
TRACK
INSTALL
KEY SLOT
VERTICAL
TRACK
3/8" - 16 X 3/4"
TRUSS HEAD BOLT
KEY
SLOT
TAB
3/8" - 16 HEX NUT
HORIZONTAL ANGLE
HORIZONTAL TRACK
19