Milling With A Compass; Maintenance And Cleaning; Disposal - Parkside POF 1200 D3 Manual Del Usuario

Milling with a compass

♦ To do this, slide the rip fence
180° (see fig. G) into the guide rails
the base plate according to the required
dimension.
♦ Tighten the locking screws
♦ Set the centring point
and tighten it using the wing screw (see fig. G).
Counter the centring point
the oblong hole of the open-ended spanner
♦ Stab the centring point
tre point of a circle.
♦ Check the setting by means of a practical test.

Maintenance and cleaning

WARNING! RISK OF INJURY!
■ Switch the appliance off and remove the
power plug before starting any work on
the appliance.
■ The appliance must always be kept clean, dry
and free from oil or grease.
■ Use a soft, dry cloth to clean the housing.
WARNING!
■ Have the power tool repaired by the service
centre or a qualified electrician and only
using genuine replacement parts. This will
ensure that the safety of the appliance is
maintained.
WARNING!
■ If the connecting cable needs to be replaced,
this must be carried out by the manufacturer
or an authorised representative in order to
avoid safety hazards.
NOTE
► Replacement parts not listed (such as carbon
brushes, switches) can be ordered via our
service centre.
│ GB │ MT
■ 52
turned by
on
.
into the rip fence
to tighten it using
.
into the marked cen-

Disposal

The packaging is made from environmen-
tally friendly material and can be dispo-
sed of at your local recycling plant.
Do not dispose of power tools in
your normal domestic waste!
European Directive 2012/19/EU requires that
worn-out power tools be collected separately and
recycled in an environmentally compatible manner.
Please consult your local authorities regarding
suitable disposal of worn out power tools.
Dispose of the packaging in an envi-
ronmentally friendly manner.
Note the labelling on the packaging
and separate the packaging material
components for disposal if necessary.
The packaging material is labelled
with abbreviations (a) and numbers
(b) with the following meanings:
1–7: plastics,
20–22: paper and cardboard,
80–98: composites
Your local community or municipal
authorities can provide information
on how to dispose of the worn-out
product.
POF 1200 D3