Publicidad
Idiomas disponibles
Idiomas disponibles
Tools
Phillips screwdriver
Screwdriver
Allan key 3, 4, 5, 6 mm
Side-cutting pliers
Wrench 10 mm (2x)
Hexagon torque wrench, 7 mm, 10 mm
Special tool for plug assembly (BMW Parts No. 61 1 132)
Scribing iron
Adhesive tape
Scissors
Knife
Hand-held power drill
Twist drill ø 8 mm, ø 2 mm
Cloth
Suitable cable (e.g. MoDiteC) with a probe and clamp for programming
Vessel for collecting leaking fuel
1
Remove the covering
Remove the seat.
Loosen the screws
screws
and remove them.
Loosen the screws
to the switch and display – place them to one side.
Loosen the fastening nuts and remove the covers on the right plug connector strip
2
Disconnect the battery
Disconnect the negative cable
d
Warning
Always turn off the ignition and disconnect the negative cable
working on the vehicle electronics or the fuel supply system.
3
Disconnect the fuel tank
Disconnect the cable to fuel pump at the plug connection
Disconnect the fuel lines at the couplings
Warning
d
The fuel lines are under pressure. Observe all safety regulations when handling fuel.
4
Remove the fuel tank
Disconnect the vent connection
Loosen the screws
Loosen the screw
Pull the fuel tank
5
Only for vehicles with case holder or supporting strap
Loosen the screws
pieces
.
Loosen the screws
and the snap closures
(right/left), remove the inner panels
from the battery and insulate it.
from the fuel tank.
(right/left).
.
to the back and remove it from the rubber mountings
and remove the case holder or the supporting strap
and remove the rear cover
(right/left), pull the side sections
and – after loosening the cable connection
from the battery and insulate it before
.
.
.
17
off of the fastening
.
and place it to one side.
with both fastening
Publicidad
