Publicidad
Idiomas disponibles
Idiomas disponibles
Using the double-sided adhesive tape
with a self-locking nut
Using the knob tape
Attention
e
It is important to use the new self-locking nuts provided in the retrofit kit.
Connect both central sockets and the connecting cable for the control LED to the cables leading to the
front of the vehicle
11
Lay the cable assembly
Connect the socket
Thread the cable assembly of the anti-theft alarm system and the adapter cable for the control LED
towards the front of the vehicle into the front covering. When doing so lay the cable on the bottom of
the sub-frame
Lay the cable
socket connector
Lay the adapter cable
Connect the cable
socket
in the right plug connector strip.
Note
L
The functions of the plug and socket connectors are described under Section
On the right plug connector strip remove the top of the 12-poled plug and socket connector
cable
(cable color green) from position 4, equip it with a connector shell
(cable color black) from the cable assembly of the anti-theft alarm system. Insert the second cable
(cable color black) into position 4 of the 12-poled plug and socket connector and reconnect the plug
and socket connector (see Section
Using a cable tie, fasten both central plugs
The programming plug
Using the cable ties fasten all cables to the existing cables or to the frame and sub-frame.
Warning
d
Lay the cables along the existing cable assembly or the frame of the vehicle in such a manner that they
are not damaged and do not impede the functionality of the vehicle.
Do not lay the cables along Bowden cables, fuel lines, brake cables, coolant lines or the oil lines.
12
The function of the plug connectors
1. Multi-pole plug connectors
Disassembly
Open both the brackets
slightly and push the locking piece
the front
and pull out the cable
Assembly
Insert the cables
locking piece
brackets
snap together.
In addition, the multi-pole connectors possess a fastening profile
can be loosened by pressing the tongue
2. Single-pole plug connectors
The assembly/disassembly of the cables corresponds to the procedure with multi-pole plug connec-
tors. However, in this case, the locking piece
M4 and a washer. Connect the motion sensor to the control unit
fix the remote control receiver
.
to the fuel pump connector (see Section
.
and
(cable color 2x black, see Section
.
for the control LED upwards along the sub-frame.
with the blue 4-pin plug (see Section
, Connection D).
A
(see Section
and separate the plug connector
outwards
.
into the connector shell
inwards until it locks into place. Push the two connector shells together until the two
fix the motion detector
to the holder or the sub-frame.
, Connection D) to the 12-poled plug and
, Connection G) to the free, blue matching
;
to the rear frame.
, Connection F) must be easily accessible.
. Open up the rear of the connector shell
. Press the special tool
from the rear until they click into place, then push the
.
of the cables is located at the side.
19
to the holder and screw it in place
, Connection C).
.
and connect it to cable
into the connector shell from
on their underside. This fastening
.
, remove
Publicidad
