Publicidad
Idiomas disponibles
Idiomas disponibles
15
Assemble the vehicle
Warning
d
Before connecting fuel lines make sure to disconnect the negative cable from the battery and insulate it.
Mount and connect the fuel tank.
Warning
d
When assembling the vehicle, pay careful attention to the tightening moments of the fastening screws
as specified in the repair manual.
Fit the cover of the plug connector strip.
Mount the inner covering and the side paneling.
Connect the negative cable to the battery and mount the seat.
16
Programming the anti-theft system
The beep and siren and tone type can be freely programmed to diverge from the standard factory set-
tings. The automatic activation of the immobilizer and alarm can be set to modes A, B or C according to
the customer's wishes (see accompanying operating instructions).
Function
Beeping signal
Panic alarm
Tone type (intermittent sound or steady sound)
Automatic activation of the immobilizer
Automatic activation of the alarm (blinkers and siren)
Note
L
The system can only be programmed with the system deactivated, using buttons
on the remote control.
Activating the programming modes
Wait until the system has automatically activated; this takes place approx. 15 seconds after man-
ual deactivation of the system or switching off of the ignition. Activate the programming function
as follows:
With the ignition turned off, press the button
onto the control LED
is off) and within 12 seconds use a cable to connect the negative lead of the programming plug
(cable color brown/white, see Section
Press the button
blinkers will flash twice, the control LED
B
The beeper will sound three times in succession at different pitches.
B
The programming function is active.
Remove the cable between the programming plug (cable color brown/white) and earth.
and so deactivate the system (the blinkers shine briefly, the control LED
, Connection F) to earth (battery –).
on the remote control (two beeps, then a long beeping tone will be heard, the
is off) and turn the ignition on within 12 seconds.
Mode B or C
on the remote control or press the inductive key
21
Mode A
(possible
(standard factory
settings)
setting)
On or Off
Off
On or Off
Off
steady or
intermittent
intermittent
On or Off
On
On or Off
Off
(On) and
(Off)
Publicidad
