Publicidad
Idiomas disponibles
Idiomas disponibles
Programming the system
Note
L
The anti-theft system is designed for 10 channel user programming. However, since only 5 channels are
occupied, the free channels must be skipped by pressing buttons
When a channel is reached, the control LED
button
, low pitch for button
The channels should be programmed in the following sequence:
Channel
Function
Ø
1
Beeping tone
Ø
2
Free
Ø
3
Free
Ø
4
Free
Ø
5
Panic alarm
Ø
6
Free
Ø
7
Tone type
Ø
8
Automatic activation of immobilizer
Ø
9
Automatic activation of alarm (blinkers and siren)
10
Free
Programming is complete after pressing button
consecutive beeps.
B
The settings made have been stored.
Turn off the ignition.
B
The beeper will sound three times in succession at different pitches.
B
The anti-theft system is now armed, the control LED
Deactivate the anti-theft alarm system by pressing button
Attention
e
When programming the function "Automatic activation of the immobilizer ON", the function "Automatic
activation of the alarm" can be set to ON or OFF .
When programming the function "Automatic activation of the alarm ON", the function "Automatic activa-
tion of the immobilizer" must also be set to ON.
17
Programming example for Mode B (Beeping signal ON, panic alarm ON, tone type intermittent,
immobilizer automatic OFF, automatic activation of the alarm OFF)
1. With the ignition turned off, press the button
key onto the control LED
LED
is off) and within 12 seconds use a cable to connect the negative lead of the program-
ming plug (cable color brown/white, see Section
2. Press the button
blinkers will flash twice, the control LED
B
The beeper will sound three times, the programming function is active.
3. Disconnect the cable between the programming plug/earth.
4. Press button
B
A high-pitched beep is heard.
5. Press the button
B
A high-pitched beep is heard.
).
and so deactivate the system (the blinkers shine briefly, the control
on the remote control (two beeps, then a long beeping tone will be heard, the
on the remote control (beeper ON).
(without function).
lights up and the beeper sounds once (high pitch for
or
at channel 10 and this is indicated by three
will begin to flash.
.
on the remote control or press the inductive
, Connection F) to earth (battery –).
is off) and turn the ignition on within 12 seconds.
22
or
.
Button
Button
On
Any
Any
Any
On
Any
intermittent
steady
On
On
Any
Off
Off
Off
Off
Publicidad
