Frequently Asked Questions; Technical Data - Marmitek GIGAVIEW745 Modo De Empleo

5 FREQUENTLY ASKED QUESTIONS

What if the Power ON LED [1A or 2A] is OFF?
• Check if the power adapter is placed in the power outlet.
• Unplug the power adapter from the DC IN [1K or 2K] and plug it back in.
What if the Link LED [1B or 2B] keeps blinking?
• This indicates there is no wireless link between the GigaView745 Transmitter and
Receiver. Take following steps:
• Check if both are powered ON.
• Press and release the Paring button [1E] of the Transmitter and the Paring LED [1C]
will switch ON.
• Press and release the Paring button [2E] of the Receiver and the Paring LED [2C] will
switch ON.
• After the wireless link is established the Link LED [1B and 2B] will stop blinking and
stay solid ON.
Note:
Pairing LED [1C or 2C] will go OFF in 45 seconds if there is no wireless link between the
Transmitter and Receiver.
If the Link LED [1B and 2B] continue blinking, you may have to move the Receiver clo-
ser to the Transmitter.

6. TECHNICAL DATA

Wireless
Operating range
and
Operating frequency
Compression standard
Video data rates
System security
System latency
A/V Transmitter
Supported video standard
Video input
Audio input
IR extender output
Dimensions
6
Up to 100m free field, up to 30m through walls
5GHz (5.15 – 5.35 GHz & 5.47 – 5.725 GHz)
MPEG-2
Up to 15Mbps
128-bit Advance Encryption Standard (AES)
50 ms
Auto detection of NTSC and PAL
1x S-Video or 1x RCA (Composite)
Analog stereo (2x RCA)
3.5mm jack
151 x 143 x 38 mm
© MARMITEK