Keurig K2.0-500 Serie Guia página 13

CARING FOR YOUR BREWER
CLEANING THE PACK HOLDER
1. Lift the Handle.
3. Pull out the Pack Holder Assembly (1)
and Base (2).
2. Push up while grabbing the sides of the
Pack Holder Assembly. Pull away from
the brewer.
CAUTION: Sharp needles. Do not put fingers in chamber.
4. Press the release buttons on both sides
of the Pack Holder Assembly.
Separate the Pack Holder from
the Housing.
24
5. Clean the Pack Holder (1), Housing (2)
and Base (3) with a damp, soapy,
lint-free, non-abrasive cloth and
rinse thoroughly.
2. Use a paper clip or similar tool to
loosen the clog. Rinse thoroughly with
hot water.
SECTION 2
CLEANING THE EXIT NEEDLE
1. If a clog arises in the exit needle, push
the lever of the Pack Holder to reveal
the exit needle.
3. After all pieces are cleaned, place the
Base, then the Pack Holder Assembly
into the Brew Head. Lower the Handle.
CAUTION: Sharp needles. Do not put fingers in chamber.
25