AGV SIDE SHARE EASY Instrucciones De Montaje página 5

AGV
-­‐
Cable stickers
-­‐
Keypad positioning template
-­‐
Current adaptor
To mount the REAR SHARE EASY kit on your helmet, follow these instructions.
Place the helmet upside down on a soft surface and make sure that it is stable. It is easier to fit the
kit to the helmet with the chin guard open (figure 11).
Unsnap and remove the foam cheek pads and the crown pad.
Do not under any circumstances try to remove the expanded polystyrene cheek pad bases. Do not
under any circumstances try to remove the expanded polystyrene chin guard.
Remove the EPS inserts in the expanded polystyrene protective padding (figure 12).
Remove the expanded polystyrene inserts for the earpieces.
If the use of stereo devices is not permitted in your country, disconnect the right earpiece
connector and put it back in the box (figure 13).
Position the Velcro strips on the units that house the electronics and the battery (figures 14a and
14b) making sure that the surface of the strips is the right kind to stick to the Velcro already present
on the cutaways inside the helmet.
Remove the protective film from the Velcro discs and glue them into the cutaways in the helmet for
the earpieces.
5
ENGLISH