AGV SIDE SHARE EASY Instrucciones De Montaje página 6

AGV
The plastic case with the USB cable fits into slot A while the other case goes into slot B. (figure
15).
Remove the protective film from the earpieces and position them in the polystyrene cheek pad
cutaways. The right earpiece should be positioned in such a way that the cable follows the route
shown in figure 16a. The left earpiece should be positioned in such a way that the microphone
boom follows the route shown in figure 16b. Fasten the earpiece connector in the polystyrene
cutaway (figure 16a) in such a way that it won't cause any bother when riding (only in countries
where the use of stereo devices is permitted).
Lock the microphone boom into position using the clip inside the shell (figure 17).
If necessary, use the adhesive strips supplied to fasten the cables in position (Figure 18).
Gently twist the microphone boom so that the arrow faces the mouth (figure 19).
Reassemble the crown pad and conceal the cable that connects the two plastic cases behind the
rear tab.
Reassemble the cheek pads taking care to route the keypad cable as shown in figure 20. Conceal
the USB cable between the crown pad and the cheek pad padding.
Take the adaptor you need for your model of helmet. The marking on the flat surface will guide you
as to which adaptor you need. Do NOT stick the adaptor to the helmet yet.
6
ENGLISH