1byone 471UK-0010 Manual De Instrucciones página 9

2.2 System settings needed for Windows and Mac
EN
Windows:
DE
1. By the system clock, right-click over the Speaker icon select Sounds then
the Recording tab, and then click on the USB device in the list and click
FR
Properties. Click the Advanced tab set your required bit rate and sample rate
ES
from the Default Format dropdown (normally "2 channel 16-bit 44100 Hz").
2. On the Advanced tab, in the "Default Format" section, make sure the
IT
dropdown menu is set to "2 channel 16-bit 44100 Hz".
For a more detailed walk-through of the above steps for Windows ( or if that does
not work for your version of Windows ), see Windows: accessing the Windows
Sound controls.
Mac:
1. From Apple Menu > System Preferences select "Sound" and click on the Input
tab
2. Select "USB Audio CODEC" or similar as the input device and verify the
Recording Meter shows input.
3. If the recording meter in the Sound preferences panel does not show input:
1. From the Finder, select Go > Utilities and open Audio MIDI Setup.
2. If the Audio Devices window is not visible, select Window > Show Audio
Devices.
3. Select your USB input device in the list in the left pane of the Audio Devices
window.
4. Set the Format to "44100.0 Hz" and "2ch-16bit".
For a more detailed walk-through of the above steps for Mac , see Mac and USB
input devices on the Audacity Wiki.
2.3 Launch Audacity.
If Audacity is already running when you connected the cable, choose Transport
>Rescan Audio Devices or restart Audacity.
2.4 Project Rate
Set the Audacity Project Rate in Selection Toolbar at the bottom left of the
Audacity screen to 44100 Hz :
14
2.5 Devices
Use Device Toolbar to set the recording and playback devices and to set the
recording channels to "2 (Stereo) Recording Channels", as in the below example on
Windows 10:
• The Recording Device is set to the USB device (in this case the device name, but
often called or including the phrase "USB Audio CODEC").
• Recording Channels is set to stereo.
• The Playback Device is set to the named speakers of the built-in computer sound
device.
• These settings can also be changed in Devices Preferences.
Windows calls most USB external devices "microphones". Some higher-end USB
recording interfaces may appear as their explicit manufacturer's name.
3. Software Playthrough
Use Transport > Transport Options > Software Playthrough (on/off) and click
"Software Playthrough" to turn it "on" (the checkmark is shown when it is "on").
This setting can also be enabled or disabled in Recording Preferences. Software
Playthrough lets you hear the turntable through the computer speakers when
recording. It also lets you hear the turntable without recording if you turn on
monitoring (see the next section below).
4. Monitoring
Enable monitoring to set the recording level
• Turn monitoring on by clicking once on the microphone icon in the Recording
Meter.
• In Mixer Toolbar, turn up the left-hand playback volume slider (by the speaker icon).
• The right-hand recording volume slider (by the microphone icon) can often be used
to vary the loudness of the recording, but it may not function with all turntables.
If it does not, try adjusting the output level on the turntable (often, there is a gain
control under the chassis).
Alternatively, you may be able to adjust the input level on Windows and Linux only,
usually by looking for the speaker icon by the system clock. On Windows, right-
click over the speaker icon > "Recording Devices". Then right-click over USB
Audio Codec, choose "Properties" and click the Levels tab.
15
EN
DE
FR
ES
IT