Fitting The Adapter; Important - Foppapedretti MYO Manual De Instrucciones

GB
USING THE TRAVEL SYSTEM ACCESSORIES
The MYO pushchair can be used with the following travel system accessories, MYO carrycot and
MYO infant car seat.
Remove the seat from the chassis (see the paragraph "Fitting the seat").

FITTING THE ADAPTER

Fitting the adapter (fig. 59-64)
Press button "A" on the adapter to release the locking lever, see fig. 60.
Insert the base of the adapter on the base of the chassis, in the direction shown in fig. 61.
Having fastened the adapter fully to the base, push the adapter fastening hook towards the base
to close it, a click will show that it has been secured correctly (fig.62, 63).
Lift both the metal clips of the adapter to a vertical position (fig.64).
A click will show that it has been secured correctly.
WARNING: Before use, check that the adapter has been fastened correctly.
Removing the adapter (fig.65-68)
IMPORTANT: Pull both the metal clips of the adapter outwards and fold them towards the back of
the pushchair chassis (handlebar end).
Press the release button "A" on the adapter, lift the blocking lever and remove the adapter from
the base, taking it off from the front of the chassis.
USING THE INFANT CAR SEAT AND CARRYCOT TRAVEL SYSTEM ACCESSORIES
IMPORTANT: the travel system accessories must be secured to the chassis only in the parent-facing
position (fig.69, 70).
FITTING THE CAR SEAT ACCESSORY (fig.71-75b)
Lift the plastic clip (fig.71).
Line up the locking mechanism fitted on the accessory with the adapters and press downwards until
a click is heard indicating that the accessory has been fastened correctly to the pushchair chassis
complete with adapters. Make sure that the accessory has been fastened correctly on both sides
(fig. 72, 73).
Connect the plastic pin to the connection device located on the handlebar frame by pressing
downwards. (fig. 74, 75a).
To make this operation easier, bring the handlebar close to the car seat (fig. 73) and insert the pin in
the connection device, pressing it downwards (fig. 74). Make sure it has been connected properly (fig.
75a).
WARNING: Before use, always make sure that the accessory has been secured correctly. When the
accessory is lifted upwards it must not detach from the pushchair chassis.
REMOVING THE CAR SEAT ACCESSORY (fig.76-79)
Press button "A" to release the plastic pin. First pull the right-hand lever "B" and then lever "C" in
the direction shown in the figure and remove the accessory by lifting it using the handle.
FITTING THE CARRY COT (fig. 80-83)
Line up the locking mechanism fitted on the accessory with the adapters and press downwards until
a click is heard indicating that the accessory has been fastened correctly to the pushchair chassis
complete with adapters. Make sure that the accessory has been fastened correctly on both sides.
MYO 29