Problem Solving - 3Com Wireless 11n Guia De Instalacion

Idiomas disponibles

The default wireless settings for the Router are:

If you do not have a Wireless LAN you can use the Router's default settings. Ensure that your wireless

clients have the default SSID, channel and encryption as detailed above.

If you have an existing Wireless LAN, configure the Router to use the same SSID and encryption

settings to be compatible with your existing wireless network.

If your computer has both a wired and wireless NIC installed, you must ensure that only one NIC is

used to communicate with the LAN. To use the wireless NIC, unplug the Ethernet cable and reboot

your computer.

Launch your web browser and attempt to browse to an internet web site such as www.3com.com.

If you can successfully access this site, then your wireless computer, Router and Cable/DSL modem

have been successfully configured.

3Com strongly recommends that you enable WPA encryption to improve the security of your wireless

network and you change the SSID to something other than the default. Consult the on line help or

the User Guide for details.

PROBLEM SOLVING

If you are experiencing difficulties with your installation, try the following:

•

Ensure all networking equipment is switched on. The Router should be showing a white Power

LED. If it is not, check the power adapter connection. Do not use any power adapter with your Router

other than the one supplied.

•

Ensure the Cable/DSL Modem is connected. The Router should be displaying a blue Cable/DSL

Status LED. If no LED is displayed, check that your modem is switched on and that it is connected to

the Cable/DSL port with an Ethernet cable.

•

Ensure that the computer is connected to the Router. The Router should be displaying a blue LAN

Status LED. If it is not, check that the computer is connected to one of the Router's LAN ports with an

Ethernet cable.

•

Ensure that you do not have a web proxy enabled on your computer. Go to the Control Panel

and click on Internet Options. Select the Connections tab and click on the LAN Settings button at the

bottom. Make sure that the Use Proxy Server option is unchecked.

•

If you are unable to access the Router's Web interface. Launch a web browser and enter

http://192.168.1.1. If you chose a different IP address, use that instead. Ensure that you include the

http:// prefix.

All manuals and user guides at all-guides.com

Tabla de Contenido