Publicidad
4663AFDH ASSEMBLY INSTRUCTIONS
Hex Wrench (provided), Phillips Screwdriver, Mallet or Padded Hammer, Wood Glue
Fig. 1
NOTE: Bolts should only be finger-tightened in this step.
1. Place both Long Safety Rails (G) face-down on a clean, protected surface. Position two Rail Braces
(I) over the pre-drilled holes and insert eight 6x35mm Black Hex Bolts (L). See Figure 1.
Fig. 2
Fig. 2a
NOTE: Bolts should only be finger-tightened in this step.
2. Determine if you want the access to the upper bunk to be on the left or right side of the bed.
Figure 2 shows the ladder attaching on the right to access the top bunk.
Place both Short Safety Rails (H) face-down on a clean, protected surface. Position two Rail
Braces (I) over the pre-drilled holes and insert eight 6x35mm Black Hex Bolts (L). See Figure 2.
For left-access, rotate the Short Safety Rails (H) 180 degrees and attach the Rail Braces (I) with
eight 6x35mm Black Hex Bolts (L). See Figure 2a.
TOOLS REQUIRED:
L
G
L
H
L
I
I
H
I
H
H
x 8
L
L
L
L
4663AFDH – Page 4 – 02/09
Publicidad
