Publicidad
Idiomas disponibles
Idiomas disponibles
USES
The appliance is already arranged both for filte-
ring and for suction performances.
* In its filtering version (Fig. 1), the air and fu-
mes conveyed by the appliance are depured both
by a grease filter and by an active coal filter, (to
be purchased as accessories) and put again into
circulation through the side-grids of the chimney.
For this version an air deflector (to be purchased
as accessories) placed on the superior part of the
pipe and allowing air-recycling is necessary (Fig.
1A).
* In its sucking version (Fig. 2), fumes are di-
rectly conveyed outside, through an evacuation
duct connected with the superior part of the wall
or the ceiling. Both coal filter and air deflector are
not necessary in this case.
INSTALLATION
Before installing the appliance, make sure that
none of the parts is damaged in any way. In case
of damaged parts, contact your retailer and do
not proceed with installation.
Read all of the following instructions with care be-
fore installing the appliance.
- Use an air outlet pipe of the shortest possible
length.
- Limit the number of pipe bends.
- Use a material approved by standards and re-
gulations.
- Avoid any sudden changes in pipe section (re-
commended constant diameter: 150 mm or equal
surface area).
* Before installing the appliance, in order not to
damage the appliance itself, the metal grase filter
should be removed. Such filter can be removed
by pushing the special filter handle toward the
back side of the cooker hood and turning it down-
wards so to unfasten it from its slot (Fig. 3).
Wall stirrup-fixing
* By using the special drilling jig (Fig. 4X), perfo-
rate the wall according to the pattern indicated
by the jig itself, and pay attention in order not to
damage water pipes and electric wires. Perfora-
tion should be performed with a Ø 8 mm wall-drill.
Then insert into the proper plastic reinforcements
(Fig. 4A). The hood-bearing stirrup (Fig. 4S) can
be applied by using the screws provided with the
equipment (Fig. 4B). Now hook the cooker hood
onto its bearing (Fig. 5) and then adjust horizon-
tally and vertically the position of the appliance by
acting on the special metric screws (Fig. 6).
After the appliance is adjusted, fix it by inserting
and tightening the safety screws properly (Fig.
5C).
14
Publicidad
