Transportation And Storage; Move The Machine; Store The Machine; Troubleshooting - GreenWorks GPW2000-1RBSC Manual Del Operador

If there is too much pump pressure, the nozzle can become
clogged, you can feel a pulsing sensation while you pull the
gun trigger.
5.1.1 REMOVE THE NOZZLE
1. Pull back the quick-connect collar (21) on the spray gun
wand (4).
2. Remove the nozzle (11) from the spray gun wand (4).
5.1.2 CLEAN THE NOZZLE
1. Use a straight paper clip or cleaning tool (23) to clean the
spray tip (11).
2. Flush and clean the unwanted materials out of the nozzle
(11) with the garden hose (18).
3. Install the clean nozzle (11) onto the spray wand (4).
6 TRANSPORTATION AND
STORAGE
WARNING
Disconnect the power cord and watter supply hose before

transportation and storage.

6.1

MOVE THE MACHINE

• Point the spray wand in a safe direction.
• Only hold the machine with the handgrip.
6.2

STORE THE MACHINE

WARNING
Make sure that the spray gun, the high pressure hose and the
pump are dry.
WARNING
Make sure the machine is out of the reach of children.
Use a recommended pump protector to prevent cold
weather damage during storage in winter.
• Disconnect the garden hose from machine.
• Wind the power cord and the high pressure hose.
• Clean housing and the plastic components with a moist
and soft cloth.
• Make sure that the machine does not have loose or
damaged parts. If it is necessary, follow these steps/
instructions:
• Replace the damaged parts.
• Tighten the bolts.
• If needed, call the customer service phone number
(enter number here) for servicing instructions.
• Store the machine in a dry, isolated and frost-free area.
NOTE
English
7

TROUBLESHOOTING

PROBLEM
The motor does
not start.
The machine does
not get high pres-
sure.
11
POSSIBLE SOLUTION
CAUSE
The power switch Set the power
is off. switch to the
"ON" ( | ) posi-
tion.
You do not plug Connect the power
the power cord. cord to the power
supply.
Electrical outlet Try another elec-
does not supply trical outlet.
sufficient power.
The circuit breaker Let it cool, and
is tripped. start the machine
again.
The power switch Pull the gun trig-
is on, but you do ger.
not pull the gun
trigger.
The diameter of Replace with a 1"
garden hose is too (25 mm) or 5/8"
small. (16 mm) garden
hose.
The garden hose is Make sure that the
blocked. garden hose is free
from blockage.
The water supply Open the water
is not sufficient. suppy fully.
You do not install Install the nozzle
the nozzle onto the onto the spray
spray wand. wand.
The water intake Remove the filter
filter is blocked. and make it clean
in warm water.
EN