Install The Spray Gun Holder; Install The Power Cord Storage Arm; Install The High Pressure Hose; Operation - GreenWorks GPW2000-1RBSC Manual Del Operador

EN
3.6 INSTALL THE SPRAY GUN
HOLDER
16
1. Aligh the screw sleeves of the spray gun holder (2) with
the screw holes on the upper handle (5).
2. Push the screws (16) through the screw sleeves and
tighten them with a Phillips Head Screwdriver (not
included).
3.7 INSTALL THE POWER CORD
STORAGE ARM
12
16
10
1. Attach the power cord storage arm (12) onto the fixture.
2. Align the screw (16) with the hole in the power cord
storage arm (12).
3. Push the screw (16) through and tighten it.
3.8 INSTALL THE HIGH PRESSURE
HOSE
1. Pull on the end of the hose retainer to release the high
pressure hose (1).
2. Push and turn clockwise one end of the high pressure
hose (1) into the inlet coupler (8).
English
2
8
17
1
3. Install and tighten the other end of the high pressure hose
(1) onto the water outlet (17).
4

OPERATION

WARNING
Make sure that all the connections are tight and have no
leakage before operation.
4.1 CONNECT THE WATER SUPPLY
TO THE MACHINE
For easy operation, please use a self-coiling garden hose (not
provided).
WARNING
When you operate the self-coiling hose, make sure that the
hose has no blockage.
WARNING
• The water supply must come from the water main
• Do not use hot water
• Do not use water from ponds or lakes
WARNING
Do the local regulations when you connect the garden hose
to the water supply. Direct connection through a receiver
tank or backflow preventer is usually permitted.
CAUTION
Inspect the filter in the water inlet connector before you
connect the garden hose
• If the filter is damaged, do not use the machine until the
filter is replaced.
• If the filter is dirty, clean the filter.
18
1. Uncoil the garden hose (18).
2. Let the water flow through the garden hose for 30
seconds.
3. Turn the water supply off.
8
8