Assembly - Home Decorators Collection 51549 Guía De Uso Y Mantenimiento

Assembly - Standard Ceiling Mount
1
Preparing for mounting
□
Remove the canopy ring (EE) from the fan motor assembly
(B) by turning the ring counterclockwise until it unlocks.
□
Remove the mounting bracket (A) from the fan motor
assembly (B) by loosening the two canopy screws (CC)
located in the "L shaped" slots.
□
Remove and save the two canopy screws (DD) in the round
holes. This will enable you to remove the mounting bracket
(A).
Assembly - Hanging the Fan
1
Attaching the fan to the electrical
box
WARNING: To reduce the risk of fire, electric shock or personal
injury, mount to outlet box marked "Acceptable for fan support
of 35 lbs. 15.9 kg) or less", and use screws provided with the
outlet box.
NOTE: The mounting bracket (A) is designed to slide into place
on an outlet box with the outlet box screws (II) installed.
□
Loosen the two mounting screws (II) in the outlet box.
□
Pass the 120-Volt supply wires through the center hole in the
mounting bracket (A).
□
Slide the mounting bracket (A) on to the mounting screws (II)
and center the mounting bracket (A) in relation to the outlet box.
If necessary, use leveling washers (not included) between the
slide-on mounting bracket (A) and the outlet box. The flat side of
the slide-on mounting bracket (A) should face toward the outlet
box, as shown.
□
Securely tighten the two mounting screws (II).
CC
7
Please contact 1-800-986-3460 for further assistance.
A
DD
B
EE
HOMEDEPOT.COM/HOMEDECORATORS