Commissioning - auna Graceland Touch Manual Del Usuario

EN
34

COMMISSIONING

Time setting
American version:
When the unit is put into standby mode, the LCD screen lights up and
displays the time „12:00".
European version:
When the unit is put into standby mode, the LCD screen lights up and
displays the time „00:00".
Example:
• To set the time, press and hold the PROG button on the control panel or
remote control for 3-5 seconds until „12" is displayed on the screen („12"
means that the 12-hour format has been set).
• Press the NEXT or PREV button to select between 12-hour and 24-hour
format. When „12-H" is displayed on the screen, press the PROG button
again. 00:00" will be displayed on the screen, but „12" will flash. To set
the correct hour, use the NEXT and PREV buttons on the control panel
or remote control (the time will be set in 12-hour format), then press the
PROG button to confirm. To set the correct minute, use the NEXT and
PREV buttons on the control panel or remote control (the time will be
set in 12-hour format), and then press the PROG button to confirm.
Note: The time is stored in the unit only when it is in operation or
standby mode. If you want to save the set time, do not press the POWER
switch, just press the ON/OFF button to put the unit into standby mode.
If you press the POWER switch, the time setting you have made will be
cleared and you will have to set the correct time the next time you turn
on the machine.