Maintenance Storage; Technical Service; Replacement Parts Information - Campbell Hausfeld Cl150100 Instrucciones Originales

Operating Instructions
Operation (Continued)
that are damaged or deteriorated.
pull the hose to move the tool or a
compressor. Keep hoses away from
heat, oil and sharp edges. Replace any
hose that is damaged, weak or worn.
luBRIcatIon
Air tools require lubrication throughout
the life of the tool and is the owner's
responsibility. Failure to lubricate the air
tool properly will dramatically shorten the
life of the tool and will void the warranty.
BEFORE the initial use and BEFORE and
AFTER each additional use.
AutomAtic lubricAtion
The recommended method for
lubrication is with an air line lubricator
installed as part of the air piping system.
See Figure 1. Use Campbell Hausfeld air
tool oil ST127001AV or equivalent ISO
grade 32 oil.
mAnuAl lubricAtion
If an air line lubricator is not used, the
tool must be lubricated daily.
supply before lubricating.
1. Disconnect the air tool from the air
supply.
2. Turn the air tool upside down.
3. While pulling the trigger, squeeze
approximately a 1/4 oz. of Campbell
Hausfeld airtool oil in the air inlet.
Then, push the forward and reverse
button in both directions.
4
Do not use
hoses or fittings
Never carry a tool
by the hose or
This air tool
requires lubrication
Disconnect the
air tool from the air
www.campbellhausfeld.com
lubricated, oil will discharge through
the exhaust port during the first few
seconds of operation. The exhaust port
must be directed away from your body
before applying air pressure.
4. Connect the air tool to the air supply
and cover the exhaust port with a
towel (refer to replacement parts
manual for tool features). Run the
tool in both the forward and reverse
directions for 20 to 30 seconds. Oil
will discharge from the exhaust port
when air pressure is applied.
Maintenance
stoRaGe
The air tool must be lubricated before
storing. Follow the air tool lubrication
instructions with an exception to step 4.
Only run the air tool for 2 to 3 seconds
instead of 7 to 10 seconds because more
oil needs to remain in the air tool when
storing.

technIcal seRvIce

For information regarding the operation
or repair of this product, please call
1-855-504-5678.
ReplaceMent paRts
InFoRMatIon
For information regarding where to order
replacement parts, call toll free 1-855-
504-5678.
Please provide the following information:
• Model number
• Stamped code
• Part number and description
Address parts correspondence to:
Campbell Hausfeld
100 Production Drive
Harrison, Ohio 45030 U.S.A.
After an air tool
has been