Publicidad
Idiomas disponibles
Idiomas disponibles
2.5 Connectors
2.5 Connectors
2.5 Connectors
2.5 Connectors
2.5 Connectors
Connectors are NOT jumpers. DO NOT place jumper caps over these
connectors. Placing jumper caps over the connectors will cause perma-
nent damage of the motherboard!
Connector
FDD Connector
(33-pin FLOPPY1)
(see p.2 item 16)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
Primary IDE Connector (Blue)
(39-pin IDE1, see p.2 item 8)
connect the blue end
to the motherboard
80-conductor, ATA 66/100/133 cable
Note: If you use only one IDE device on this motherboard, please set the IDE
device as "Master". Please refer to the instruction of your IDE device vendor
for the details. Besides, to optimize compatibility and performance, please
connect your hard disk drive to the primary IDE connector (IDE1, blue) and
CD-ROM to the secondary IDE connector (IDE2, black).
Shared USB 2.0 Header
(9-pin JUSB45)
(see p.2 item 25)
Internal Audio Connectors
(4-pin CD1, 4-pin AUX1)
(CD1: see p.2 item 17)
(AUX1: see p.2 item 18)
ASRock K7VT6-C Motherboard
Figure
Secondary IDE Connector (Black)
(39-pin IDE2, see p.2 item 7)
connect the black end
to the IDE devices
This USB45 connector is shared
with the USB 2.0 ports 4,5 on
ASRock I/O Plus
the front panel USB ports by
attaching the front panel USB
cable to this connector
(JUSB45), the USB ports 4,5 on
ASRock I/O Plus
to function.
These connectors allow you to
receive stereo audio input from
sound sources such as a CD-
ROM, DVD-ROM, TV tuner card,
AUX1
CD1
or MPEG card.
Description
the red-striped side to Pin1
TM
. When using
TM
will not be able
1 1
1 1
1 1
1 1
1 1
Publicidad
