Battery Installation; Operation; Directly Measurement - Gima OXY-10 Guía De Uso

• Pulse beep with pitch tone, pulse beep on/off and alarm limits can be set
via setup menu.
• Shift parameter display between PR and PI
• 2AAA alkaline batteries with low power consumption
• Low battery voltage indication

2. Battery Installation

Figure 2 Battery Installation
z
1. Refer to Figure2, insert two AAA size batteries into the battery compartment
properly.
2. Replace the cover.
Please make sure that the batteries are correctly installed, or incorrect
installation may cause the device not to work.
Σ
IVD

3. Operation

1

3.1 Directly measurement

1. Open the clip as shown in Figure 3.
PHTHALATES
Figure 3 Put finger into the Oximeter
2. Put finger into the rubber cushions of the clip (make sure the finger
is in the correct position), and then clip the finger.
3. The device will power on automatically in 2 seconds, and start to display
software version number.
4. Next enter into data display screen (as shown in Figure 4). User can read
the values and view the waveform from display screen.
ENGLISH
24