S&P EB-100 Manual De Instrucciones página 13

To adjust the timer, turn the right poten-
tiometer with a small screwdriver:
- To increase the time delay turn it Cloc-
kwise (CW).
- To decrease the time delay turn it
Counter Clockwise (CCW).
To adjust the humidity level above
which the fan will operate automatically,
turn the left potentiometer with a small
screwdriver.
Operation
The timer will operate when the Switch
(independent switch or light switch) is
switched off.
The hygrostat causes the extractor to
operate automatically when the humi-
dity level in the room is higher than the
level selected with the potentiometer.
Likewise, the extractor will stop auto-
matically when the humidity level drops
below the selected level.
The diagram on fig.7 shows how to con-
nect the unit through an independent
switch.
The diagram on fig.8 shows how to con-
nect the unit through the light switch.
EB models HT (12V~50Hz)
For these models use the CT-45/12 sa-
fety isolating transformer:
Fig. 13: To switch the transformer and
the extractor through an inde-
pendent switch.
Fig. 14: Switching the transformer and
the extractor through the light
switch.
Maintenance
IMPORTANT: Before manipulating the
ventilator, make sure it is disconnected
from the mains supply even if it has pre-
viously been switched off. Prevent the
possibility of anyone else connecting it
while it is being manipulated. The ex-
tractor needs only a periodical cleaning
using a cloth lightly impregnated with a
soft detergent.
After Sales Service
The extensive network of S&P Official
Services guarantees good technical as-
sistance all over Spain. If you observe
any anomalies in the convector, please
contact any of the above mentioned
Services, where you can get the correct
advice. Any modification that is not
strictly necessary for the installation of
the device and carried out by persons
outside of the S&P Official Services will
invalidate the guarantee.
For any queries regarding the S&P Pro-
ducts go to the S&P After Sales Ser-
vice network if is Spanish territory or
your dealer in the world. For the nearest
location you can consult the webpage:
www.solerpalau.com.
Recycling
EEC Standards, together with
the responsibility we should
assume with future genera-
tions in mind, oblige us to re-
cycle all the materials we can.
Therefore, please deposit all left-over
material and packaging in their corres-
ponding recycling containers and hand
in the replaced machines to the nearest
handler of this type of waste product.
S&P reserves the right to alter specifica-
tions without notice.