Care And Maintenance - Toolland WEH200 Manual Del Usuario

Intermittent Rating
This appliance is designed for
operation).
rated load for
minutes to
the total
Overload
• The appliance is not
overload and overheating by a
• If the permissible
temperature
switch
• In case
the cooling
• In case of direct exposure
significantly, which will also
possible that the temperature
will shut
8.

Care and Maintenance

• Always disconnect the appliance from the mains before starting any cleaning, maintenance
or servicing work.
• In the following: One cycle means one raising and lowering movement of a load. Periodic
inspection means an inspection after 100 cycles.
Cleaning
• Keep all safety devices, air vents and the motor housing free of dirt and dust.
• Wipe the appliance with a clean cloth or blow it with compressed air at low pressure. Clean
the appliance regularly with a moist cloth and some soft soap. Do not use cleaning agents
or solvents as these could attack the plastic parts of the appliance. Ensure that no water
can seep into the appliance.
• We recommend that you clean the appliance immediately after each use.
Maintenance
• A check must be made every 30 cycles to find whether the entire steel cable is in good
condition. If it is damaged (split or bent, see illustration below), it must be replaced by a
steel cable of the type specified in the technical data.
• Check that the power supply cable, motor stop switch and the push button are in good
working condition.
Servicing
• Periodically test that the limit switches on the cable hoist are in correct working order.
Conduct this test as follows: when the cable has reached the maximum height, the lever on
the automatic stopping mechanism will be actuated. The motor must then stop (test
without a load).
V. 07 – 24/06/2021
WEH200/WEH300
operating type S3 20 % -
The relative duty cycle
2.0 minutes during
cool off. The appliance
operating cycle of 10 minutes
suitable
operating time is
switch will shut
back on after a cooling
of a strain on the appliance
time will decrease.
to
decrease the permissible
down. Please wait until the device is
10 min.
is 20 %, which means that the appliance
each operating cycle and
can therefore be continuously
at rated load.
for continuous operation.
temperature switch.
exceeded, the motor temperature
the appliance off. The temperature
phase.
with a lesser load,
sunlight, the temperature
switch will switch off after a short period and
cooled off.
WARNING
11
(periodic intermittent
can be
must then be switched off
used for a duration
The motor is protected from
will increase
switch will automatically
the operating time will increase and
of the casing will increase
operating time. It is therefore
the appliance
operated at
for 8
of 20 % of
and the
©Velleman nv