Craftsman CMXGZBF71242131 Manual De Instrucciones página 8

ENglISh
Step 12: (fig. 12)
1. Turn the lift handle as shown in figure 12 and attach it
to the side of the wheel bracket that is indicated. Use a
shoulder spacer (M), two 3/8" x 1-1/4" hex bolts (C) and
two 3/8" nylock nuts (I) to attach the wheel bracket to
the lift lever. Tighten the bolts and nuts. See figure 12.
Please note this is a difficult step.
2. Push the grip (V) onto the lift handle. See figure 12.
Fig. 12
3/8" x 1-1/4"
HEX BOLT (C)
3/8" x 1-1/4"
HEX BOLT (C)
3/8" NYLOCK
NUT (I)
6
GRIP (V)
WHEEL BRACKET
SHOULDER
SPACER (M)
3/8" NYLOCK
NUT (I)
Step 13: (fig. 13)
Perform the following steps in sequence to tighten the bolts
and nuts that remain loose. Refer to figure 13.
1. Turn the aerator upright, then lock the lift handle into
the transport position.
2. Tighten the four bolts at the left corners of the tray.
3. Tighten the two bolts which fasten the middle brace to
the bottom of the tray.
4. Tighten all hardware
Fig. 13
c
PUSH AGAINST
THIS SIDE
b
c
c
d
c