Zodiac eXPERT Manual De Instalación Y De Uso página 74

4.3.15. User interface energy saving mode
By default, the screen power saving mode is activated and an appliance which is unused goes into standby: an
animated production indicator is displayed and the measured values are not visible. To deactivate this mode:
• From the Configuration/D15 ECO mode, press
• Press to switch to "ON".
• Press to confirm.
4.3.16. "Bio": "Bio pool" mode for natural pools
The "Bio" mode is used to modify the pH and ORP setpoints and the related high and low alarms (see the values in the
table below) so they are best suited to natural pools.
pH
ORP (mV)
By default, this mode is disabled; to activate it:
• From the Configuration/bio mode, press
• Press to activate it ("ON").
• Press to confirm.
4.3.17. Calibrating the temperature
• From the home screen, press
to enter the Calibration mode. The screen displays
• Press
• Press to select this mode. The value flashes.
• Press or to change the value.
• Press to confirm.
Press at this step to switch between a temperature display in degrees Celsius (°C) and degrees Fahrenheit
(°F).
4.3.18. Calibrating the salt concentration
• From the home screen, press twice on
• Press to enter Calibration mode. The screen displays
• Press to select this mode. The value flashes.
• Press or to change the value.
• Press to confirm.
31
« Bio pool »
mode
OFF (default) 7.0
ON 6.5
OFF (default) 600
ON 300
: "OFF" flashes.
to access the temperature values (*).
to access the salinity values.
: "OFF" flashes.
Threshold
7.8
8.5
850
850
("Standard").
("Standard").
Alarm
High (HI) Low (LO)
> 8.5 < 6.5
> 9.0 < 6.0
> 855 < 600
> 855 < 300